Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into contact with the sealant. Check keyfob battery and function. Check for continuity between Intelligent Key unit harness connector M42 terminal 10 and ground. Remove the cluster lid C bracket screws. Disconnect steering lock solenoid connector. Terminals Condition Voltage V Approx. Does the Bluetooth system operate normally? The noise characteristics are provided so the customer, service adviser and technician are all speaking the same language when defining the noise.
Open the front door and adjust up or down at the rear edge according to specification. Remove the bolt and disconnect the trunk lid release cable. For this reason, if the battery is disconnected or if the battery is discharged, the steering wheel will lock and steering wheel rotation will become impossible. Check continuity between Intelligent Key unit harness connector M42 A terminal 4 and Intelligent Key warning buzzer front of vehicle harness connector E26 B terminal 3. Repairs can usually be made by moving, adjusting, securing, or insulating the component causing the noise.
Dealer may charge additional administration fees, which may vary by dealer. Connector Item Terminals Condition Voltage V Approx. Key switch Intelligent Key unit input check. The Bluetooth microphone sends a signal to the Bluetooth control unit. Rear seat belt anchor inner reinforcements 43. Connect Intelligent Key unit connector.
Terminal Signal name Condition Resistance Ω Approx. In addition look for: 1. Check continuity between satellite radio tuner and ground. The hazard and buzzer reminder has a horn chirp mode C mode and a non-horn chirp mode S mode. While operating the hood release handle, carefully check that the front end of the hood is raised by approx. Disconnect spiral cable connector M78. Even if Intelligent Key battery runs down, Intelligent Key unit can start engine with mechanical key built into Intelligent Key.
Remote Keyless Entry Function check. Install clutch cover and then temporarily tighten clutch cover mounting bolts. Refer to the cellular telephone operating manual. . Bluetooth control unit B15, B62, B69 2.
Check voltage between microphone connector R4 terminal 4 and ground. Also check that the hood release handle returns to the original position. Disconnect front door request switch connector. Bluetooth telephone system allows users who have a Bluetooth cellular telephone to make a wireless connec-tion between their cellular telephone and the Bluetooth control unit. Separate the outside handle cable from the outside handle bracket. Therefore, when such a panel is replaced or repaired, apply undercoating to that part. Driver side 5 - 3 : Continuity should exist.
Check voltage between microphone connector R4 terminal 4 and ground. Passenger side 25 - 3 : Continuity should exist. Most of these incidents are repaired by pushing up on the console at the clip locations until the clips engage. Disconnect the Bluetooth control unit connector C. Disconnect Intelligent Key unit connector.
After the display test, the design of the display previously available is stored. Disconnect satellite radio tuner connector B56 A and audio unit connector M45 B. The steering lock will remain released and the steering wheel can be rotated. Combination meter M24 warning lamp indicators 12. Check continuity between audio amplifier harness connector ter-minal and ground. Remove master cylinder rod end from clutch pedal assembly.
Horn relay H-1 front of battery 9. Disconnect Intelligent Key warning buzzer front of vehicle connector. Remove the rear door harness grommet. Check continuity between audio unit connector terminal and spi-ral cable connector terminal. Disconnect combination meter security connector.
Ignition switch warning chime is operated. To help pinpoint the source of the noise, use a listening tool Chassis Ear: J-39570, Engine Ear: J-39565 and mechanic's stethoscope. Disconnect clutch interlock switch harness connector. Check that the secondary latch is properly engaged with the secondary striker B: 6. If necessary, grease or replace it. Tighten clutch cover mounting bolts to the specified torque evenly in two steps in the numerical order as shown. Disconnect Intelligent Key unit connector.