See the Wet Compression - Increase table in the Base Manual. No Gap e Remove the following parts. Smooth the sealing surfaces with fine emery cloth if necessary. Mounting Bolts eRemove the front fender. A short or open in one of the coil wires will result in either a low output, or no output at all. I have just acquired a 1994 220 that runs, however seems to have tranmission issues.
Fuel Tank Damper Installation -Apply an adhesive which is recommended by the manufacturer for bonding rubber to metal to the inside of the rubber dampers and install them as shown. If at 3A charge rate Hours of Ch arglng. You can also create custom bookmarks and find that information you need over and over again, quickly and easily. If it is not installed correctly, the starter will not operate properly. Pickup Coil Inspection eMeasure the pickup coil resistance. Side Electrode Spark Plug: The spark plug ignites the fuel and air mixture in the combustion chamber. Pull the cable out of the vehicle.
Sealant Crankshaft Runout Left Half Standard: Service Limit: Right Half Standard: Service Limit: Under 0. Suitable Stand elnflate the tire until the tire beads seat on t he rim. Shaft Camshaft Chain, Guides, and Tensioner Camshaft Chain Tensioner: Camshaft Chain Tensioner Removal A. Muffler Clamp Bolt eWork the exhaust pipe out of the frame and remove it. Reverse Cable Adjustment -Remove the front propeller shaft cover see Engine Left Side chapter.
Example2: Decrease the thickness of the drive bevel gear shim s by 0. Cylinder Head' Mounting Bolt and Nut -Remove the cylinder base bolt. Propeller Shaft Sliding Joint B. Longer bracket faces the front. Locking Pliers eHold the reel in one hand wh il e removing the locking pliers with the other. Front Propeller Shaft Front Axle Front Propeller Shaft Removal Front Axle Joint Boot Inspection eRemove the front propeller shaft cover using the socket wrench special tool: 57001-1268.
Reverse Knob and Cable Installation. Thickness mm Part Number O. Once it is discharged, the plates sUlphate turn white , and the battery will no longer take a charge. Do not use any other fluid for cleaning these parts. Steering Knuckle Steering Knuckle Removal in the Steering chapter Front Axle Cap Bolts A. Mounting Bolts eTake off the front fender along with the carrier. Olnflate the tire to 35 kPa 0.
Make sure the area is well ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Valve Guide Reamer: 57001-162 A. The purpose of toe-in is to prevent the front wheels from getting out of parallel at any time, and to prevent any slipping or scuffing action between the tires and the ground. . Do not remove it yet.
Rear Propeller Shaft Joint Boot e When installing the engine, note the following. Be sure to heed the fluid manufacturer's warnings. Ends eAlign the relief marks on the steering stem clamps. Seal Lips -Tighten the knuckle joint nuts to the specified torque see Exploded View. Okg·m, 87ft·lb T 3 : 20 N. Shift Lever Case and Cable Removal. Apply a soap and water solution around the tire bead and check for bubbles.
Front Propeller Shaft Cover B. Otherwise, install a new gasket. Suspension Arm Pivot Shaft D. Hexagon Wrench: 57001-1194 eRemove the gears and the shifter. When using a battery charger, connect the battery to the charger before turning on the charger. Table 12 V 1 9 Ah.